you have your teleportation rune set up, and if you haven’t yet,
look at the full-page
diagram; let us go
through how to use it.
First, you need to set up your pathway, or tunnel, to the place you
want to go. Do this by extending the outer ring of energy (from your
destination) upwards to the desired location- through dimensions; so
the tunnel is actually quite short and just splices into where you
want to go.
It is time to connect the tunnel to your means of going through it. Cause the five elemental energies to course through the straight lines of the rune, blending together and tying the center ring to the tunnel. Double check this step to make sure you have a strong connection.
At this point, you are essentially ready to teleport, but before you do this, there is another step. You need to make a clone of your now-ready teleportation circle and place it at your destination; right where the tunnel connects to. Do this by simply willing another prepared circle to appear over the tunnel connection.
The final step is the teleportation itself. Your tunnel is ready to receive you. Remember the large mass of energy, right under your feet? Cause it to surge upwards; and will it as hard as you can to push you through the tunnel, to your destination. Remember that this requires an immense amount of energy and will. Its focused and harnessed by using a crystal, or gemstone.
Congratulations! Hopefully, you have just accomplished your first teleportation! If not, however, just go back and keep trying. This takes a lot of practice.
Just as you
can push yourself through a dimensional tunnel; you can also pull
yourself through a dimensional tunnel. This can be done if a
teleportation circle already exists at the place you want to go.
Repeat the basic method, but this time make the tunnel extend towards
When you have done this, bring the beam of propulsion energy (found
in the center ring) to you, make sure it has a firm holding on the
rune, and simply have the energy pull you along and to the location.
Don’t have enough room to draw out the whole rune? This problem is easily solved. Just draw the rune on a sheet of paper, and place it on the floor in front of you. Proceed to place the energies in their required places on the rune, and begin to connect the tunnel. When this is done, all you have to do is stretch the tunnel itself (not the paper representation) outwards until it has reached the desired size, and step into it. You now have your appropriately sized teleportation circle.
SpellHawk for the idea of a teleportation rune; and to the rest of
the Casa Umbrae crowd (Caroline, Jordan, Nikola, Ben, Kio, and a few
more) for advice and getting me into magic.
For more information on this sort of thing; register on
out Spell Hawk’s comprehensive magic and language sites: